Filter
Top Products
17
junction box (A, Figure 21), tilt blade to 45
degrees, and remove right side cover.
Figure 21
The plug on the end of the motor cord must be
replaced with a UL/CSA listed plug rated for
240V.
9.3 Overload reset button
If saw becomes overloaded and the motor shuts
off, push the re-set button on motor junction box
(B, Figure 21) to restart. If overloading happens
frequently, consult the Troubleshooting section
in this manual.
9.4 Extension cords
USE PROPER EXTENSION CORD. Make sure
your extension cord is in good condition. When
using an extension cord, be sure to use one
heavy enough to carry the current your product
will draw. An undersized cord will cause a drop
in line voltage resulting in loss of power and
overheating. Table 1 shows correct size to use
depending on cord length and nameplate
ampere rating. If in doubt, use the next heavier
gauge. The smaller the gauge number, the
heavier the cord.
Ampere
Rating
Volts
Total length of
cord in feet
More
Than
Not
More
Than
120
240
25
50
50
100
100
200
150
300
AWG
00 06 18 16 16 14
06 10 18 16 14 12
10 12 16 16 14 12
12 16 14 12
Not
Recommended
Extension Cord Recommendations
Table 1
9.5 On-off switch padlock
The Table Saw is equipped with a push-button
switch that will accept a safety padlock, as
shown in Figure 22. To safeguard your machine
from unauthorized operation and accidental
starting by young children, the use of a padlock
(not included) is highly recommended. Place the
key in a location that is inaccessible to children
and others not qualified to use the tool.
Figure 22
10.0 Adjustments
Disconnect saw from power
source before making adjustments.
10.1 Blade raising/tilt mechanism
Never try to force the tilting
mechanism past the 45º or 90º stops. This
may cause the blade to go out of alignment.
Referring to Figure 23:
To raise or lower blade, loosen lock knob (A)
and turn handwheel (B) on front of saw until
desired height is reached. Tighten lock knob.
The blade should be adjusted about 1/8" above
the top surface of the material being cut.
To tilt blade, turn lock handle (C) counter-
clockwise to loosen, turn handwheel (D) until
desired angle is obtained, then tighten lock
handle (C) clockwise.
Figure 23
10.2 Adjusting 45º and 90º positive
stops
1. Disconnect saw from power source.
2. Raise blade to maximum height.