Filter
Top Products
25
Figure 45 – Push stick template
13.0 Maintenance
Always disconnect power to
the machine before performing maintenance.
Failure to do this may result in serious
personal injury.
Cleaning
Clean the JPS-10TS according to the schedule
below to ensure maximum performance.
Note—The following maintenance schedule
assumes the saw is being used every day.
Daily:
Wipe down the table surface and T-slots
with a rust preventive.
Clean pitch and resin from the saw blade.
Weekly:
Clean motor housing with compressed air.
Wipe down fence rails with a dry silicon
lubricant.
Lubrication
Lubricate the areas indicated below every 12
months.
Lubricate blade angling trunnions with 6 or
7 drops of light machine oil.
Lubricate the blade height trunnion with 6
or 7 drops of light machine oil.
Worm gears and threads should be
lubricated with an automotive wheel
bearing grease.
Check all adjustments after lubricating.
Miscellaneous
Always be aware of the condition of your
machine. Routinely check the condition of the
following items and repair or replace as
necessary:
Mounting bolts
Power switch
Saw blade
Blade guard