Filter
Top Products
16
Electrical Connections
WARNING!
All electrical connections must be done by a
qualified electrician!
Failure to comply may result in loss of
property and/or serious injury!
• JWBS-16 is rated at 1-1/2 HP, 1Ph,
115V/230V, prewired 115V.
The bandsaw comes with a 115V plug (A, Fig.
22). If you switch the motor to 230V a plug
needs to be purchased for the bandsaw that
matches the 230V outlet you intend to use.
Confirm power at the site is the same as the
saw before making any electrical connections.
Review the wiring diagram on page 30.
Review “Grounding Instructions” on page 4,
“115 Volt Operation” also on page 4, and 230
Volt Operation on page 5.
Maintenance
Keep blade guides clean and free of build up.
Do not let saw dust build up in the upper and
lower wheel housings. Vacuum out frequently.
Connect the bandsaw to a JET dust collection
system.
Clean and grease the raising/lowering rack for
the upper blade guides if it becomes difficult to
raise, or lower.
Clean, and oil the tensioning mechanism if it
becomes difficult to adjust.
Vacuum out the motor fan cover.