Filter
Top Products
11
K. Headstock Faceplate: (K, Fig. 7)
Used for turning bowls. There are a number of
screw holes for mounting the workpiece.
Thread the faceplate onto the spindle in a
clockwise direction. Remove the faceplate by
pushing in headstock spindle lock and using
the provided wrench on faceplate flats.
L. Headstock Spur Center: (L, Fig. 7)
Used for turning between centers. Spindle
taper is MT-2. Remove spur center by inserting
drift rod through the opposite end of the spindle
and knocking spur center out.
M. Headstock Indexing Hole: (M, Fig. 7)
Thread indexing pin into the indexing hole
making sure that it locates in the spindle hole.
There are 12 holes in the spindle 30° apart.
Three holes in the headstock casting accept
the indexing pin. These holes are 20° apart.
The combination of holes will allow you to mark
your workpiece for evenly spaced features. See
chart on page 29.
Never start the lathe with the
index pin engaged in the spindle!
N. Tool Rest Body Lock Handle: (N, Fig. 8)
Locks the tool rest body in position. Unlock
handle to position the tool rest in any location
along lathe bed. Tighten handle when properly
positioned.
O. Tool Rest Lock Handle: (O, Fig. 8)
Locks the tool rest in position. Unlock the
handle to position tool rest at a specific angle,
or height. Tighten handle when properly
positioned.
P. Tailstock Lock Handle: (P, Fig. 9)
Locks the tailstock in position. Unlock handle to
position the tool rest in any location along lathe
bed. Tighten handle when properly positioned.
Q. Tailstock Quill Lock Handle: (Q, Fig. 9)
Locks the tailstock quill in position. Unlock
handle to position the quill. Tighten handle
when properly positioned.
R. Tailstock Quill Handwheel: (R, Fig. 9)
Turn the handwheel to position the quill. The
tailstock quill lock handle must be loose to
position quill.
S. Tailstock Live Center: (S, Fig. 9)
Used for turning between centers. Quill taper is
MT-2. Remove live center by retracting the quill
until live center loosens.
Figure 7
Figure 8
Figure 9