Filter
Top Products
20
Optional Accessories
Safety Guard
The JWL-1442VS Safety Guard is an optional
accessory.
Referring to Figure 26:
1. Mount the guard bracket (A) to the headstock
with two 3/8” flat washers, two 3/8” lock
washers and two 3/8”-16 x 1-1/2” socket head
cap screws (B).
2. Attach the guard (C) to the guard bracket by
inserting the rod and lifting up on the plunger
(D).
3. There are two detents that will hold the guard in
place. One is for turning and the other is for
when you need the guard up and out of the
way. Simply lift up on the plunger and rotate
the guard until the plunger slips into the detent.
Tighten the bushings (E) against the bracket with
two setscrews (F).
Tool Basket
Referring to Figure 27:
1. Mount the bracket (A) to the inside of the lathe
leg with two 5/16”-18 x 1-1/2” Hex Socket Cap
Screws, four 5/16” flat washers and two 5/16”
hex nuts (B).
2. The two setscrews, on the bracket should be
below the bolts and accessible for adjustment.
3. Place the arm of the tool basket into the
bracket and tighten with a 5/16”-18 x 5/8” set
screw and a 5/16” hex nut (C). Line up the
notch in the arm with the setscrews so the tool
basket can pivot.
4. Adjust the set screws on the bracket so that the
tool basket swings in a level manner. Tighten
the two hex socket cap screws.
Figure 26
Figure 27