Filter
Top Products
16
Appendix
Leica DISTO™ D8 LCA782205a gb
D
GB
F
I
E
P
NL
CN
key). The distance measuring key is active in both levels. The functionality
of the direction keys depends on the software used.
Transmitting the measurement
If your software supports the direction keys use them to select the appro-
priate position for the cursor.
Press the button briefly to transfer the value from the summary row
to the pocket PC / PC.
For further details please consult your manual for the software used.
Selecting particular values in the display
The display shows a number of measurements (min., max., last measu-
rement taken). By pressing and holding the button you can select all
measurements in the display for transmitting (blue lines under the measu-
rements). When you press the - key or the - key you can select
one specific value. Once selected the measurement can be transmitted
using the - key. The same selection process can be used for areas,
volumes, indirect measurements and room dimensions.
During data transmission
If the data is not confirmed as being successfully received by the Pocket PC/
PC then no new measurement can be processed. The Info code "240"
appears in the display if no data transmission has taken place after 2
seconds. Press the - key and repeat the measurement and then
transmit it.
)
If Bluetooth transmission is limited, the PC may have Bluetooth
hardware with a shorter range. In this case we recommend the usage of an
external Bluetooth USB adapter of class 2.
)
The free software supplied is designed to provide the user with
basic functionality. Leica Geosystems provides no warranty for this free
software and offers no support for it. Leica Geosystems accepts no liability
whatsoever arising from the use of the free software and is not obliged to
provide corrections nor to develop updates or upgrades.
You can find numerous commercial vendors of software for a wide range
of applications on our homepage.
Appendix
Message codes
All message codes are displayed with either or "Error". The following
errors can be corrected:
Cause Remedy
156
Transverse tilt greater than 10° Hold the instrument without
any transverse tilt
162
The calibration has not been
accomplished on a levelled
surface and the calibration value
is respecitvely within an
ineligible area.
Calibrate the device on an abso-
lute horizontal levelled surface.
204
Calculation error Repeat procedure
240
Data transfer error Repeat procedure
245
2nd button pressed although no
Bluetooth connection exists.
Establish Bluetooth connection
252
Temperature too high Cool down instrument
253
Temperature too low Warm up instrument
255
Receiver signal too weak,
measurement time too long,
distance > 100 m
Use target plate
256
Received signal too strong Target too reflective (use target
plate)
257
Wrong measurement,
background brightness too high
Darken target (measure in diffe-
rent lighting conditions)
260
Laser beam interrupted Repeat measurement