LevelOne FBR-1700TX Grinder User Manual


 
29
Chapter 4
PC Configuration
This Chapter details the PC Configuration required on the local ("Internal")
LAN.
Overview
For each PC, the following may need to be configured:
TCP/IP network settings
Internet Access configuration
Printer installation
Windows Clients
This section describes how to configure Windows clients for:
Internet access via the LevelOne Broadband Router
Sharing the Printer connected to the LevelOne Broadband Router.
The first step is to check the PC's TCP/IP settings.
The LevelOne Broadband Router uses the TCP/IP network protocol for all functions, so it is
essential that the TCP/IP protocol be installed and configured on each PC.
TCP/IP Settings - Overview
If using the default LevelOne Broadband Router settings, and the de-
fault Windows TCP/IP settings, no changes need to be made.
By default, the LevelOne Broadband Router will act as a DHCP Server, automatically
providing a suitable IP Address (and related information) to each PC when the PC boots.
For all non-Server versions of Windows, the default TCP/IP setting is to act as a DHCP
client.
If using a Fixed (specified) IP address, the following changes are re-
quired:
The Gateway must be set to the IP address of the LevelOne Broadband Router
The DNS should be set to the address provided by your ISP.
If your LAN has a Router, the LAN Administrator must re-
configure the Router itself. Refer to Chapter 8 - Advanced
Setup for details.
4