Introduction
5
Components - FBR-1100TX
Figure 2: Components - FBR-1100TX
1
LED Link Indicator
(WAN Port)
On - WAN connection (to broadband modem) is established.
Off - No WAN connection (to broadband modem)
Flashing - Data is being transmitted or received via the
WAN port.
2
WAN port
(10BaseT)
Connect the 10BaseT cabling (RJ45 connector) for the
External LAN, WAN, or DSL/Cable Modem here.
3
LAN port
(Auto-sensing
10/100BaseT)
Connect the LAN cable (RJ45 connectors) from this port to a
10BaseT or 100BaseT hub.
4
LED Link Indicator
(LAN Port)
On - LAN connection is using 10BaseT.
Off - No LAN connection.
Flashing - data is being transmitted or received via the LAN
port
5
Reset Button This button has 2 functions:
• When pressed and released, the Broadband Router will
reboot (restart).
• This button can also be used to clear ALL data and
restore ALL settings to the factory default values.
To restore the factory default values:
1. Power Off
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until
the RED LED has flashed TWICE.
4. Release the Reset Button. The Broadband Router is now