Filter
Top Products
LIFTING
The Vantage lift bale should be used to lift the machine. The
Vantage is shipped with the lift bale retracted. Before attempting
to lift the Vantage the lift bale must be secured in a raised
position. Secure the lift bale as follows:
a. Open the engine compartment door.
b. Locate the 2 access holes on the upper middle region
of compartment wall just below the lift bale.
c. Use the lifting strap to raise the lift bale to the full upright
position. This will align the mounting holes on the lift
bale with the access holes.
d. Secure the lift bale with 2 thread forming screws. The
screws are provided in the shipped loose parts bag.
------------------------------------------------------------------------------------
HIGH ALTITUDE OPERATION
At higher altitudes, output derating may be necessary. For
maximum rating, derate the welder output 4% for every 300
meters (984 ft.) above 1500 meters (4920 ft.). For output of 500A
and below, derate the welder output 4% for every 300 meters
(984 ft.) above 2100 meters (6888 ft.).
Contact a Cummins Service Representative for any engine
adjustments that may be required.
HIGH TEMPERATURE OPERATION
At temperatures above 40°C (104°F), output voltage derating
may be necessary. For maximum output current ratings, derate
welder voltage rating 2 volts for every 10°C (21°F) above 40°C
(104°F).
TOWING
The recommended trailer for use with this equipment for road, in-
plant and yard towing by a vehicle
(1)
is Lincoln’s K953-1. If the
user adapts a non-Lincoln trailer, he must assume responsibility
that the method of attachment and usage does not result in a
safety hazard nor damage the welding equipment. Some of the
factors to be considered are as follows:
1. Design capacity of trailer vs. weight of Lincoln
equipment and likely additional attachments.
2. Proper support of, and attachment to, the base of the
welding equipment so that there will be no undue stress
to the trailer’s framework.
3. Proper placement of the equipment on the trailer to
insure stability side to side and front to back when being
moved and when standing by itself.
4. Typical conditions of use, such as travel speed,
roughness of surface on which the trailer will be
operated, and environmental conditions.
5. Proper preventative maintenance of trailer.
6. Conformance with federal, state and local laws
(1)
.
(1)
Consult applicable federal, state and local laws regarding
specific requirements for use on public highways.
VEHICLE MOUNTING
Improperly mounted concentrated loads may cause unstable
vehicle handling and tires or other components to fail.
• Only transport this Equipment on serviceable vehicles
which are rated and designed for such loads.
• Distribute, balance and secure loads so vehicle is stable
under conditions of use.
• Do not exceed maximum rated loads for components such
as suspension, axles and tires.
• Mount equipment base to metal bed or frame of vehicle.
• Follow vehicle manufacturer’s instructions.
--------------------------------------------------------------------------------------
A-3 INSTALLATION A-3
Vantage 500 CUMMINS
• Lift only with equipment of
adequate lifting capacity.
• Be sure machine is stable
when lifting.
• Do not lift this machine
using lift bail if it is
equipped with a heavy
accessory such as
trailer or gas cylinder.
FALLING • Do not lift machine if
EQUIPMENT can lift bail isdamaged.
cause injury. • Do not operate machine
whilesuspended from lift
bail.
WARNING
WARNING