Filter
Top Products
F-6
DIAGRAMS
F-6
RANGER 305G
or servi ce thi s equipment.
Only qualified per sonnel should install,use
Keep away f r om moving part s.
Keep guards in place.
MO V I NG P A R T S c an i njure
WARNING
Do not touch elect r i cal ly live part s.
before servi cing.
Di sconnect NEGATIVE ( -) Battery lead
Do not operate wi th panel s open.
EL ECTRI C SHOC K c an kill
14 PIN
AMPHENOL
TO WORK
+
_
ENGINE W ELDERS /LN-8 CONNECTION DIAGRAM
S24787-6
4-14-2000
TO LN-8 INPUT
CABLE PLUG
ELECTRODE CABLE
TO WIRE FEED UNIT
CAUTION:
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE W
IL
AN INCREASE IN THE AC WIRE FEEDER VOLTAGE, WHICH CAN DAMAGE THE CONTROL CIRCUIT. THE ENGINE GOVERNOR SETTING I
S
AT THE FACTORY — DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN THE ENGINE WELDER OPERATING MANUAL.
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
APPLICATIONS. SEE OPERATING MANUAL.
N.B. CONNECT WELDING CABLES TO OUTPUT STUDS FOR DESIRED POLARITY. POSITION THE WIRE FEEDER VOLTMETER SWITCH
TO
MATCH THE POLARITY OF THE ELECTRODE CABLE.
N.C. PLACE IDLER SWITCH IN HIGH POSITION.
K595 CONTROL CABLE