Filter
Top Products
'(*,!'&
$&R(!(
, *%$$%','*'.*$'
The thermal light illuminates when the wire
drive motor draws too much current. If the
thermal light illuminates, the wire drive will
automatically shutdown for up to 30 seconds to allow
the motor to cool. To start welding again, release the
gun trigger, inspect the gun cable, liner (and conduit).
Clean and make repairs as necessary. Start welding
again when the problem has been safely resolved.
For best results, keep the gun cable and conduit as
straight as possible. Perform regular maintenance
and cleaning on the gun liner, conduit and gun.
Always use quality electrode, such as L-50 or L-56
from Lincoln Electric.
('/*-(+)-&
All of the LED’s will briefly illuminate during power-up.
If the gun trigger is activated during power up, the
feeder will not operate until the gun trigger is released.
/!*+(%(*!+($0
!6>7
The left display shows the preset I;D78776EB776.
The right display shows '.. The wire feed speed
LED is lit.
/7>6;@9
The value in the left display will be either 3?BE or
actual I;D78776EB776, depending upon the selection
chosen in the set-up menu. The corresponding LED
below the display will light. Note that actual WFS may
not match preset WFS, if welding at low voltages with
high wire feed speeds. The right display shows the arc
HA>F397. If the wire feeder is connected for electrode
negative welding, then the voltage display shows a
minus sign.
8F7D/7>6;@9
The display continues to hold the value of the 3?B7D
397 or /+ and 3D5HA>F397 for five seconds after
welding stops. The 3?B7D397 or /+ and HA>F397
displays flash.
+7F-B%7@G
78AD77@F7D;@9F:7E7FGB?7@G
Set the display to the desired wire feed speed (exam-
ple: 400 inches per minute)
Measure the actual wire feed speed (example: 405
inches per minute)
Place the WFS knob in the 12 o’clock position.
To enter the set-up menu, use paper clip to press the
small 4GFFA@ located on the case front.
AVERTISSEMENT
AV
WFS
AVERTISSEMENT
AV
WFS
AVERTISSEMENT
AV
AMPS
VOLTAGE
AVERTISSEMENT
AV
AMPS
VOLTAGE
BUTTON
BUTTON