Filter
Top Products
. ))##& %
*B;@6>7'>357?7@F
The wire reel stand provides two mounting locations
for the spindle. Each mounting location consists of a
tube in the center of the mast and locating slots.
#A36;@9FA>4V=9*BAA>E
1. Squeeze the release bar on the retaining collar and
remove it from the spindle.
2. Place the spool on the spindle, aligning the spindle
brake pin with one of the holes in the back side of
the spool. An indicator mark on the end of the spin-
dle shows the orientation of the brake holding pin.
Be certain the wire feeds off of the spool in the
proper direction.
3. Re-install the retaining collar. Make sure that the
release bar snaps out and that the retaining collar
fully engages the groove on the spindle.
#A36;@9FA>4V=9*BAA>E
A K468 spindle adapter is required for loading 2" wide
spools on 2" (51mm) spindles. Use a K468 spindle
adapter for loading 2-1/2" (64mm) wide spools.
1. Squeeze the release bar on the retaining collar and
remove it from the spindle.
2. Place the spindle adapter on the spindle, aligning
the spindle brake pin with the hole in the adapter.
3. Place the spool on the spindle and align the
adapter brake tab with one of the holes in the back
side of the spool. An indicator mark on the end of
the spindle shows the orientation of the brake tab.
Be certain the wire feeds off of the spool in the
proper direction.
4. Re-install the retaining collar. Make sure that the
release bar snaps out and that the retaining collar
fully engages the groove on the spindle.
9. Loosen the two screws on the bottom of the feed
plate clamping collar.
10. Rotate the feed plate to the desired position.
11. Tighten the two screws on the bottom of the feed
plate clamping collar.
,)
12. Remove the rear access panel on the wire drive.
13. Locate DIP switches on the Wire Drive Board.
14. Set DIP switch #8 to the desired setting.
15. Reinstall the rear access panel to the wire drive.
16. Restore power.
LOW SPEED
SCREW SETTING
HIGH SPEED
SCREW SETTING
S
CREW FOR ROTATING
FEED PLATE
CLAMPING COLLAR SCREWS
LOW SPEED
SCREW SETTING
HIGH SPEED
SCREW SETTING
S
CREW FOR ROTATING
FEED PLATE
CLAMPING COLLAR SCREWS
'*I;F5:'AE;F;A@
ON
OFF
73D)3F;A
High speed
Low speed (default)
%*+##+ &%
'&.)S$* %#. ))