Filter
Top Products
))%()
&%-(R#+"-((
!#""(%$$*%$
For any gun having a newer style Miller connector.
Install gun adapters per the instructions shipped with
it.
!%.%%$$*%$
For any gun having an OXO style connector. Install
gun adapters per the instructions shipped with it.
%$+*&*()
!&*(
for use with Lincoln Magnum conduit and E-Beam
conduit (wire sizes 1/16 - .120)
For Magnum conduit:
Install the K1546-2 gun adapter at the incoming end of
the feed plate, secure with the set screw located at
the back of the feed plate. If a brass fitting is supplied
with the conduit, remove it from the feeder end of the
conduit by unscrewing it. Insert the conduit into the
K1546-2, secure the conduit by fastening it the the
adapter with the supplied knob screw.
For E-Beam Conduit:
Install the K1546-2 gun adapter at the incoming end of
the feed plate, secure with the set screw located at
the back of the feed plate. Insert the conduit into the
K1546-2, secure the conduit by fastening it the the
adapter with the supplied knob screw.
+" &(%+( )-*
%&*%$)
!+"&(%+()-*
Kit includes gun switch, and mountings for Lincoln
Innershield and Magnum guns, with 15 ft. (4.5m) con-
trol cable and 5-pin plug with two leads to connect to
gun trigger.
Connect the 5-pin plug of the K683-3 Dual procedure
Switch to the Power Feed 10 Dual Wire Feeder
Trigger/Dual Procedure 5-socket receptacle.
The two lead plug cord extending out of the 5-pin plug
of the Dual Procedure switch is to be connected to the
two trigger leads of the welding gun per instructions
shipped with the kit.
!+"&(%+()-*
The K683-3 Dual Procedure Switch is the recom-
mended method of obtaining dual procedure for non-
Fast-Mate guns; but a K683-1 can be used. For using
a K683-1 with a fast mate gun, see USING DUAL
PROCEDURE WITH FAST-MATE GUNS. A K683-1
Dual Procedure Switch can be used on the Power
Feed 10 Dual if a K686-2 adapter is used. The K686-2
kit includes the gun switch and mountings for Lincoln
Innershield and Magnum guns, with 15 ft. (4.5 m) con-
trol cable and 3-pin plug. K686-2 Adapter permits the
3-pin plug from the K683-1and 5-pin gun trigger plug
to be connected to the 5-pin trigger/dual procedure
receptacle on the wire feeder.
+)$+" )+" -*)*
#*+$)%$)()()
Configuration 1
K489-9 Dual Schedule Fast-Mate adapter
K575-[ ] Magnum 400 DS/FM gun (or competitive
DS/FM gun)
Configuration 2
*
K489-9 Dual Schedule Fast-Mate adapter
K683-1 Dual Procedure Switch (3 pin)
K686-2 "Y" adapter (3pin + 5 pin to 5 pin)
* Non-DS Fast-Mate gun (Magnum 450WC, Magnum 200, Magnum 300,
Magnum 400, and others)
!-*(%$$*%$!*
Install per the instructions shipped with the kit.
! -*( "%- )$)%(
!*
Install per the instructions shipped with the kit