Filter
Top Products
B-13
OPERATION
B-13
EXPLANATION OF PROMPTING
AND ERROR MESSAGES
Display Prompt or Error
Acc Displayed on Voltage display, indicates WFS
display is showing acceleration setting, “1" to
“5" (See “Acceleration Selection” in this sec-
tion).
OFF Displayed on WFS and voltage displays; indi-
cates limits for WFS or voltage are off for the
displayed procedure. (See “Maximum and
Minimum Limits Setting Modes” in this sec-
tion).
SEC Displayed on WFS display, indicates Voltage
display is showing a Timer setting in sec-
onds. (See “Display Control Keys” in this
section)
GLP Displayed on WFS display, indicates that the
Grounding Lead Protector circuit was activat-
ed due to excessive current flow into the
wire feeder frame. When the GLP circuit is
activated the wire feeder is disabled (the trig-
ger output to the power source is opened up,
the motor is stopped, and the gas solenoid is
turned off). To resume normal operation,
release the trigger, make sure that the elec-
trode is not touching the wire feeder frame,
and then either press a key on the keypad or
close the trigger. (See “Grounding Lead
Protector” in this section)
Cld Displayed on Voltage display when Cold
Feed Forward or Cold Feed Reverse Key is
pressed, or Cold Feed Trigger mode is
selected. Indicates wire is fed “cold” (no
weld voltage) at the speed indicated on the
WFS display. (See “Operation Keys” and
“Trigger Mode Selection” in this section).
--- Displayed on Voltage or WFS displays with
RUN-IN selected, indicates setting will match
those set for Weld Voltage and Wire Feed
Speed (See “Display Control Keys” in this
section).
HXX Displayed on WFS display, indicates wire feed over-
load. XX indicates time remaining in seconds before
unit resets automatically. (See “Wire Feed Overload
Protection” in this section and “Avoiding Wire
Feeding Problems” in the MAINTENANCE section).
Er EEPROM error. Usually occurs at power-up.
Indicates one or more of the recalled settings is out
of acceptable limits. Press any key to return to nor-
mal operation. Be sure to check all voltage, wire feed
speed, acceleration and timer settings before you
proceed.
LN-10