ADDITIONAL SAFETY RULES
1.
Rags, cloth, cord, string and the like should never be left around the work
2.
Avoid cutting nails. Inspect for and remove all nails from the workpiece before
3.
Handle the blades very carefully.
4.
Be sure the blade installation bolts are securely tightened before operation.
5.
Hold the tool firmly with both hands.
6.
Keep hands away from rotating parts.
7.
Before using the tool on an actual workpiece, let
it
run
for a while. Watch
for vibration or wobbling that could indicate poor installation or a poorly
balanced blade.
8.
Make sure the blade is not contacting the workpiece before the switch is
turned on.
9.
Wait
until
the blade attains
full
speed before cutting.
area.
operation.
IO.
Keep at least
200
mm
(8”)
away from the tool at all times.
1 1.
Always switch off and wait for the blades to come to a complete stop before
12.
Never stick your finger into the chip chute. Chute
may
jam when cutting
13.
Do
not leave the tool running. Operate the tool only when hand-held.
14.
When leaving the planer, switch off and set
it
with
the front base
up
on a
15.
Always change both blades or covers on the drum, otherwise the resulting
any adjusting.
damp wood. Clean out chips with a stick.
wooden block,
so
that the blades do not contact anything.
imbalance
will
cause vibration and shorten tool life.
SAVE THESE INSTRUCTIONS.
4