Filter
Top Products
13
Table insert (Part No. 317934-3)
When cutting grooves, use this table insert instead of the
standard table insert.
To install the dado head set, proceed as follows:
1. Turn the tool off and unplug it before installing.
2. Remove the blade guard with the spreader.
3. Install the dado head set with the teeth pointing
down at the front of the table.
4. Use the chart below to select the proper cutters to
obtain the various cutting widths.
CAUTION:
• For a 1/8” cut width, the outside cutter is assembled
to the spindle in the same manner as the saw
blade.
• The outer flange must be used for each cut width.
• The hex nut alone must not be used to secure the
dado on to the spindle.
NOTE:
• When widths slightly greater than the above are
required, fit the paper washers in between the
inside and outside cutters to adjust the width.
5. Arrange the cutters so that the tips of the inside cut-
ters are positioned at the gullets of the outside cut-
ter. When more than one inside cutter is used,
space the tips of the inside cutters equidistantly in
006176
CUT
WIDTH
1/8"
1/4"
5/16"
3/8"
7/16"
1/2"
Spindle
Inner
flange
Outside
Cutter
1/8"
Inside
cutter
1/16"
Inside
cutter
Outside
Cutter
Outer
flange
Hex
nut
x2
9/16"
5/8"
11/16"
3/4"
13/16"
x2
x3
x3
x4
x4
Inner
flange
006177