Filter
Top Products
10
Remove the tool base from the tool. Loosen the wing bolts
and secure the tool base horizontally. Loosen the two screws
on the tool base.
Place the templet guide on the tool base. There are four con-
vex portions on the templet guide. Secure two of the four
convex portions using the two screws. Install the tool base on
the tool.
Secure the templet to the workpiece. Place the tool on the
templet and move the tool with the templet guide sliding
along the side of the templet.
NOTE:
• The workpiece will be cut a slightly different size from the
templet. Allow for the distance (X) between the router bit
and the outside of the templet guide. The distance (X)
can be calculated by using the following equation:
Distance (X) = (outside diameter of the templet guide –
router bit diameter) / 2
Straight guide (optional accessory)
The straight guide is effectively used for straight cuts when
chamfering or grooving.
1. Base
2. Wing bolt
3. Screws
4. Screwdriver
1
2
3
4
002006
1. Templet guide
2. Convex portions
1
2
002007
1. Straight bit
2. Base
3. Templet
4. Distance (X)
5. Workpiece
6. Templet guide 10
1
2
3
4
5
6
10mm(3/8")
001988
001989