Filter
Top Products
12
Circular work
Circular work may be accomplished if you assemble the
straight guide and guide plate as shown in the figure.
Min. and max. radius of circles to be cut (distance between
the center of circle and the center of bit) are as follows:
Min.: 70 mm (2-3/4”)
Max.: 221 mm (8-11/16”)
For cutting circles between 70 mm (2-3/4”) and 121 mm
(4-3/4”) in radius.
For cutting circles between 121 mm (4-3/4”) and 221 mm
(8-11/16”) in radius.
NOTE:
• Circles between 172 mm (6-3/4”) and 186 mm
(7-5/16”) in radius cannot be cut using this guide.
1. Wing nut
2. Wave washer
3. Flat washer
4. Guide plate
5. Straight guide
6. Centre hole
7. Bolt
1
2
3
4
5
6
7
001993
1. Wing nut
2. Wave washer
3. Flat washer
4. Guide plate
5. Straight guide
6. Centre hole
7. Bolt
1
2
3
4
5
6
7
001994