Filter
Top Products
13
Align the center hole in the straight guide with the center of
the circle to be cut. Drive a nail less than 6 mm (1/4”) in
diameter into the center hole to secure the straight guide.
Pivot the tool around the nail in clockwise direction.
Trimmer guide
Trimming, curved cuts in veneers for furniture and the like
can be done easily with the trimmer guide. The guide roller
rides the curve and assures a fine cut.
Loosen the wing bolts and secure the tool base horizontally.
Install the trimmer guide on the tool base with the clamp
screw (A). Loosen the clamp screw (B) and adjust the dis-
tance between the bit and the trimmer guide by turning the
adjusting screw (1 mm (3/64”) per turn). At the desired dis-
tance, tighten the clamp screw (B) to secure the trimmer
guide in place.
When cutting, move the tool with the guide roller riding the
side of the workpiece.
1. Nail
2. Centre hole
3. Straight guide
1
2
3
002010
002011
1. Clamp screw (A)
2. Adjusting screw
3. Clamp screw (B)
4. Trimmer guide
5. Wing bolt
1
2
3
4
5
002012
1. Workpiece
2. Bit
3. Guide roller
1
2
3
001998