Filter
Top Products
Position
0
-
For cutting in soft
steel,
stainless
steel
and plastics.
For clean cuts
in
wood and plywood.
Position
I
-
For cutting in soft
steel,
aluminum and hard wood.
Position
I1
-
For cutting in wood and plywood.
For fast cutting in aluminum and soft
steel.
Position
111
-
For fast cutting in wood and plywood.
Switch
action
Tool speed
is
increased by increasing pres-
Lock
button
sure on the trigger. To start the tool,
simply pull
the
trigger.
Release
the
trigger
to stop. For continuous operation, pull the
trigger and then push in the lock button.
To stop the tool from the locked position,
pull the trigger fully, then release
it.
A
speed control screw
is
provided
so
that
maximum tool speed can be limited (vari-
able). Turn the speed control screw clock-
wise for higher speed, and counterclock-
wise for lower speed.
CAUTION
:
Before plugging in the tool, always check to
see
that the trigger switch actuates properly
and returns to the "OFF" position when released.
Operation
Turn the tool on and wait until the blade
attains full speed. Then rest the base
flat
on the workpiece and gently move the tool
forward along the previously marked cut-
ting line. When cutting curves, advance the
tool very slowly.
CAUTION
:
Failure to hold the tool base flush with the workpiece may cause blade breakage.
7