Makita 5026DWB Cordless Saw User Manual


 
FUNCTIONAL DESCRlPTfON
Installing or removing battery cartridge
*Always switch off the tool before inser-
tion or removal of the battery cartridge.
To
remove the battery cartridge, withdraw
it
from
the
tool while pressing the buttons
on both sides
of
the cartridge.
*To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Always insert it all the way until it
locks in place with
a
little click. If not, it
may accidentally fall out of the tool, causing injury to you or someone around you.
easily, it is not being inserted correctly
Do not use force when inserting the battery cartridge. If the cartridge does not slide in
Charging
*Your new battery cartridge is not charged.
You will need to charge
it
before use. Use
the high capacity battery charger Model
DC1801 to charge the battery cartridge.
Plug
the high capacity battery charger into
the proper A.C. voltage source. The charg-
ing light will flash in green color.
*Insert the battery cartridge
so
that the
plus and minus terminals on the battery
cartridge are on the same sides as their
respective markings on the high capacity
battery charger. Insert the cartridge fully
into the port
so
that it rests on the charger port floor.
When the battery cartridge is inserted, the charging light color
will
change from green
to
red and charging will begin. The charging light will remain lit steadily during charging.
When the charging light color changes from red to green, the charging cycle is complete
and the charger will switch into its "trickle charge (maintenance charge)" mode. The
charging time is approximately one hour.
After charging, unplug the charger from the power source.
CAUTIO N:
The high capacity battery charger Model DCI 801 is for charging Makita battery cartridge.
Never use
it
for other purposes or for other manufacturer's batteries.
When you charge
a
new battery cartridge or
a
battery cartridge which has not been used
for
a
long period of time, it may not accept
a
full charge. This is
a
normal condition and
does not indicate
a
problem. You can recharge the battery cartridge fully after discharging
it
completely and recharging
a
couple of times.
11