Filter
Top Products
IMPORTANT SAFETY INSTRUCTIONS
FOR CHARGER
&
BATTERY CARTRIDGE
1.
SAVE
THESE
INSTRUCTIONS
-
This manual
Length of Cord (Feet)
AWG Size of Cord
contains important safety and operating instructions for battery charger.
2.
Before using battery charger, read all instructions and cautionary markings
on
(1)
battery charger,
(2)
battery, and
(3)
product using battery.
3.
CAUTION
-
To
reduce risk of injury, charge only MAKITA Battery Cartridge
7000, 7001, 7002, 7033, 7100, 7120,
9000,
9001,
9002,
9033,
9100,
9101,9102,9120,9122,9133,1200,1201,1202,1210,1211,1220,1222,
1233,
1422,
1433,
9101A. 9102A, 1201A. 1202A. 1822 or
1833.
Other
types of batteries may burst causing personal injury and damage.
4.
Do not expose charger to rain or snow.
5.
Use of an attachment not recommended or sold by the battery charger
manufacturer may result
in
a risk of fire, electric shock, or injury to persons.
6.
To
reduce risk
of
damage to electric plug and cord, pull by plug rather than
cord when disconnecting charger.
7. Make sure cord is located
so
that
it
will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
8.
An extension cord should not be used unless absolutely necessary. Use
of
improper extension cord could result
in
a risk of fire and electric shock. If
extension cord must be used, make sure:
a. That pins on plug of extension cord are the same number, size, and shape
b. That extension cord is properly wired and
in
good electrical condition; and
c. That wire size is at least as large as the one specified
in
the table below.
TABLE
1
RECOMMENDED MINIMUM AWG SIZE
FOR
EXTENSION CORDS
FOR
BATTERY CHARGERS
as those of plug on charger;
25
50
100
150
18
18
18
16
9.
Do
not
operate charger with damaged cord or
plug
-
replace
them
im-
mediately.
IO.
Do not operate charger
if
it
has received a sharp blow, been dropped, or other-
wise damaged
in
any way; take
it
to a qualified serviceman.
11.
Do not disassemble charger or battery cartridge; take
it
to a qualified
serviceman when service or repair is required. Incorrect reassembly may
result
in
a risk
of
electric shock or fire.
12.
To reduce risk
of
electric shock, unplug charger from outlet before attempt-
ing any maintenance or cleaning. Turning off controls
will
not reduce this risk.
9