Filter
Top Products
If
you
charge a battery cartridge from
a
just-operated tool or
a
battery cartridge which has
been left in
a
location exposed to direct sunlight or heat for
a
long time, the charging light
may flash in red color. If this occurs, wait for
a
while. Charging will begin after the battery
cartridge cools. The battery cartridge will cool faster
if
you remove the battery cartridge
from the high capacity battery charger.
If the charging light flashes alternately in green and red color,
a
problem exists and charg
ing is not possible. The terminals on the charger or battery cartridge are clogged with
dust or the battery cartridge is worn out or damaged.
Trickle charge (Maintenance charge)
If
you leave the battery cartridge in the charger to prevent spontaneous discharging after
full charge, the charger will switch into its “trickle charge (maintenance charge)” mode and
keep the battery cartridge fresh and fully charged.
Tips for maintaining maximum battery life
1. Charge the battery cartridge before completely discharged.
Always stop tool operation and charge the battery cartridge when you notice less tool
power
2.
Never recharge
a
fully charged battery cartridge.
Overcharging shortens the battery service life.
3.
Charge the battery cartridge with room temperature at
10°C
-
40°C (50°F
-
104°F).
Let
a
hot battery cartridge cool down before charging it.
Hex
wrench
Hex wrench storage
When not in use, the hex wrench can be
conveniently stored.
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is removed before e
any adjustment
is
attempted.
12