Filter
Top Products
Fig. 12
[3] DISASSEMBLY/ASSEMBLY
[3]-6. Blade Case Complete
DISASSEMBLING
1. Remove retaining ring WR-26 and Flat washer 26.
Use 1R003 equipped with Claw of 1R212,
when removing retaining ring WR-26.
2. Remove Safety cover, Tension spring 4 and Thickness ring.
3. Remove the parts of LED section,
Rubber sleeve 6, M5-8 Hex socket
head set screw and M6 Hex nut.
4. Remove Bearing box (Gear section)
by unscrewing four M4x16 pan head
screws.
(1) Remove Lever 55 and M6x85 Hex bolt as per the top right drawing in Fig. 5.
Now the machine is free from Depth guide.
(2) Make the machine free from Angular guide as drawn in Fig. 8.
Now the machine is separated from Base completely.
(3) Separate Blade case as per the upper left, upper right and lower left drawings in Fig. 10.
(4) Disassemble Safety cover and Gear section from Blade case as drawn in Fig. 12.
Cover
Retaining
ring WR-26
<Note in Disassembling>
Hold the Retaining ring with your gloved hand
so that it does not spring when removing.
Flat washer 26
Safety cover
Tension spring 4
Thickness ring
Connector box
Connector
LED
Gasket
Gear section
M4x16 Pan
head screw
(4pcs.)
4x20 Tapping screw
Rubber
sleeve 6
M6 Hex nut
M5-8 Hex socket
head set screw
LED section
Repair
P 9/ 16