Filter
Top Products
Reversing switch action
I
This tool has a reversing switch to change
the direction
of
rotation. Move the lever
to
the
'
position for clockwise rotation or
the
*
position for counterclockwise
rotation
u
Switch trigger
~
CAUTION:
Always check the direction of rotation before operation.
Use the reversing switch only after the tool comes to a complete stop. Changing the direc-
Do
not pull the switch trigger when the reversing switch lever is in the neutral position.
tion of rotation before the tool stops may damage the tool.
If
you pull the trigger forcibly, the switch may be damaged.
Selecting the action mode
This tool employs an action mode changing
knob. Select one
of three modes suitable for
your work needs by using this knob. For
rotation only, turn the knob
so
that the arrow
on the knob points toward the mark on
the tool body. For hammering only, turn the
knob
so that the arrow on the knob points
toward the
+
mark on the tool body. For
rotation with hammering, turn the knob
so
that the arrow on the knob points toward
the mark on the tool body.
/
\'
Action
mode
changing
knob
CAUTION:
The action mode changing knob may not be turned to your desired mode mark when
the tool is not running. In this case, pull the switch trigger half-way and turn the knob
while the tool
is
running under no load at low speed.
Always set the knob fully to your desired mode mark. If you operate the tool with the
knob positioned half-way between the mode marks, the tool may be damaged.
I1