Filter
Top Products
Installing or removing the battery cartridge
Always switch off the tool before insertion or removal of the battery cartridge.
To
remove the battery cartridge, pull out the
set plate on the tool and grasp both sides
of the cartridge while withdrawing
it
from
the tool.
To
insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip
it
into place.
Snap the set plate back into place. Be sure
to close the set plate fully before using the
tool to prevent the battery cartridge from
accidentally falling out of the tool.
easily, it is not being inserted correctly.
Do not use force when inserting the battery cartridge. If the cartridge does not slide in
Charging
Your new battery cartridge is not charged.
You will need to charge
it
before use. Use
the fast charger Model DC1201 to charge
the battery cartridge.
Plug the fast charger into the proper AIC
voltage source. The charging light will flash
in green color.
Insert the battery cartridge
so
that the plus
and minus terminals on the battery car-
tridge are on the same sides as their
respective markings on the fast charger.
Insert the cartridge fully into the port
so
that
it
rests on the charger port floor.
When the battery cartridge is inserted, the charging light color will change from green
to red and charging will begin. The charging light will remain lit steadily during chrging.
When charging is completed, the charging light color will change from red to green and
a tone will sound steadily for about
5
seconds.
After charging, unplug the charger from the power source. Refer to the table below for
the charging time.
Battery cartridge
Fast charger
DC1201
Battery cartridge
1200 Approx.
45
min.
1201 or 1201A
Approx.
60
min.
8