Filter
Top Products
P 8/16
Repair
[3] DISASSEMBLY/ASSEMBLY
[3] -5. Blade Case, Blade Cover, Safety Cover
Fig. 7
Fig. 8
DISASSEMBLING
(1) Separate Motor housing and Armature from Blade case section as described in Fig. 7.
1. Remove Carbon brush. 2. Remove three M5x45 Pan head screws.
3. Separate Motor housing from Blade case section. 4. Remove Armature together with Shaft lock
and Compression spring 7.
Rubber washer 13
Note:
If Rubber washer 13 falls off Motor housing in this step,
put it back into Bearing box of Motor housing.
Carbon brush
Brush holder
cap
Brush holder
cap
Compression spring 7
Armature
Shaft lock
(2) Remove both Angular guide section and Rear angular guide section from Base. (Fig. 2)
(3) Remove Depth guide and M6x8 Hex bolt from Blade case. (Fig. 4)
(4) Remove Safety cover together with Tension spring 4, Bearing box and other parts from Blade case. (Fig. 8)
Rubber sleeve 6
M5x8 Hex socket
set screw
M6x20 Pan head screw
M5x16
Pan head screw
O Ring 44
Bearing box
Retaining ring S-42
Use 1R003 for removing Retaining ring S-42.
Safety cover
Tension spring 4