Filter
Top Products
P 9/16
Repair
[3] DISASSEMBLY/ASSEMBLY
[3] -5. Blade Case, Blade Cover, Safety Cover
Fig. 9
Fig. 10
DISASSEMBLING
(5) Remove Blade cover as described in Fig. 9.
1. Remove two M4x12
Pan head screws.
2. Grab Blade cover at the tab and the bottom
with your forefinger and thumb, then lift it
up a little and put the rib portion of Blade
case on the edge of Blade case.
3. Pull off Blade cover from
Blade case by sliding it
in the direction of the arrow.
tab
Blade cover
Blade case
ASSEMBLING
(1) Mount Bearing box on Blade case. (See the right illustration in Fig. 8.)
(2) Mount Tension spring 4 on Blade case and Safety cover as described in Fig. 10.
(3) Set Retaining ring S-42 in place with 1R003. (See the left illustration in Fig. 8)
(4) Take the reverse step of Disassembling. (Fig. 7)
Blade side Motor housing side
Blade case
Tension spring 4
Safety cover
Insert the hook from Blade side to Motor housing side.
Insert the hook from Motor housing side to Blade side.
rib portion,
put on the edge
of Blade case