Filter
Top Products
ADDITIONAL SAFETY RULES
1.
Don't use the tool in the presence of flammable liquids or gases.
2.
Check the blade carefully for cracks or damage before operation. Replace
cracked or damaged blade immediately.
3.
Use only flanges specified for this tool.
4.
Be careful not to damage the arbor, flanges (especially the installing sur-
5.
Make sure that the turn base is properly secured
so
it
will not move during
6.
Always keep the table top clear of chips, small pieces and
so
on
in
order
7.
Avoid cutting nails. Inspect for and remove all nails from the workpiece be-
8.
Make sure the shaft lock is released before the switch is turned on.
9.
Be sure that the blade does not contact the turn base in the lowest position.
face) or bolt. Damage to these parts could result
in
blade breakage.
operation.
to maintain a safe, clean surface.
fore operation.
IO.
Hold the handle firmly.
11.
Keep hands away from rotating parts.
12.
Make sure the blade is not contacting the workpiece before the switch is
turned on.
13.
Before using the tool on an actual workpiece, let
it
run for a while. Watch
for vibration or wobbling that could indicate poor installation or a poorly
balanced blade.
14.
Wait
until
the blade attains full speed before cutting.
15.
Stop operation immediately if you notice anything abnormal.
16.
Do
not attempt to lock the trigger in the on position.
17.
Always switch off and wait for the blade to come to a complete stop before
removing, securing workpiece, changing workpiece position, angle or the
blade itself.
18.
Don't abuse cord. Never yank cord to disconnect
it
from the receptacle. Keep
cord away from heat, oil, water and sharp edges.
WARNING
For Your Own Safety Read Instruction
Manual Before Operating Miter Saw
1.
Wear eye protection.
2.
Keep hands out of path of saw blade.
3.
Do
not operate saw without guards
in
place.
4.
Do
not perform any operation freehand.
5.
Never reach around saw blade.
6.
Shut off power and wait for saw blade to stop before servicing or adjusting
tool.
SAVE THESE INSTRUCTIONS.
4