Filter
Top Products
Emptying
dust
bag
When the dust bag
is
about half full, re-
move the dust bag from the tool and pull
the fastener out. Empty the dust bag of
its
contents, tapping
it
lightly
so
as
to
remove
particles adhering to the insides which
might hamper collection.
I
Fig.
14
Securing workpiece
By
turning the knob on the
vise
counterclockwise, the screw
is
released and the
vise
shaft
can be moved rapidly in and out.
By
turning the knob clockwise, the screw remains
secured.
To
grip workpieces, turn the knob gently clockwise, until the projection reaches
its
topmost position, then fasten securely.
If
the knob
is
forced in or pulled out while
being turned clockwise, the projection may stop
at
an angle. In this
case,
turn the knob
back counterclockwise until the screw
is
released, before turning again gently clock~se.
CAUTION
:
.Grip workpieces only when the projec-
tion
is
at
the topmost position. Other-
wise the workpiece cannot be properly
gripped and might pop out or damage the
blade.
(Dangerous way
to
grip workpiece)
Fig.
17
0
When making miter cuts of
35
degrees or more, to the side that the
vise
is
mounted, the
safety cover movement may be slightly obstructed by the
vise.
This only occurs when
the workpiece dimensions are more than
90
mm (3-1/2”) in width and
less
than 60 mm
(2-3/8“) in height, or
less
than
90
mm (3-1/2”) in width and
less
than 30 mm (1-3/16”)
in height.
If
this situation occurs, re-mount the
vise
on the other side of the tool’s base.
9