Makita RP2301FC Router User Manual


 
Wiring diagram
RP2300FC with LED Job Light, Electronic Control
Fig. D-3B
Lead wire holder
Wiring in Motor housing
on top side (Rear cover side)
Wiring in Grip R
Support unit
When putting Support unit’s Lead wires
into Lead wire holders, put them as follows.
* Support unit’s Lead wire (black)
into Lead wire holder of outside
* Support unit’s Lead wire (orange)
into Lead wire holder of inside
Controller
Support unit’s Lead wire (orange) Support unit’s Lead wire (black)
Put Controller into
the above illustrated
position.
RP2300FC with LED Job Light, Electronic Control
Insulated connector
Connect Insulated connector to
Switch terminal 2 while keeping
it away from Boss.
Switch terminal 2
Boss
P 15/ 27