Filter
Top Products
Repair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Reciprocating Mechanism (cont.)
ASSEMBLING
(4) After setting DC motor and Reciprocating mechanism to Housing L, assemble Slider section and Leaf spring (Fig. 7).
Fig. 7
5. Make sure to insert O ring 5 into the bottom of
assembling holes for Slider guide.
7. Assemble Slider with Seal plate, Slider support
and Slider guide to Housing L while inserting
the elliptical hole of Slider into Collard sleeve 4.
8. Facing the flat side of Leaf spring to
the front, insert it into the assembly
hole discribed below vertically.
9. Make sure to put Holder and Retainer
complete in Housing L before mounting
Housing R.
O Ring 5
Housing L
Housing R
Collared
sleeve 4
Seal plate
Slider support
Slider guide
Elliptical hole
Slider
Retainer
complete
Holder
6. Turn DC motor shaft to move Collared sleeve 4 to
the top position so as to reserve the space for
assembling Slider section.
Assembling holes
P 6/ 11