Filter
Top Products
22
ENGLISH
ON/OFF switch
• To turn the motor ON:
Press and hold the ON/OFF switch
(43).
• To turn the motor OFF:
Release the ON/OFF switch.
Rotating table
For mitre cuts the rotating table (44) can,
after loosening the lock screw (46) and
the table lock lever (45), be rotated 47°
to the left or 47° to the right.
The rotating table engages into positive
stops at the 0°, 15°, 22.5°, 30°, and 45 °
position.
A
Caution!
To keep the mitre angle from
changing while sawing, the lock
screw of the rotating table must be
tightened.
Push/pull action
The track arm permits the cutting of
workpieces having a larger cross sec-
tion. The track arm can be used for all
type of cuts (standard cross cuts, mitre
cuts, bevel cuts, compound mitre cuts).
When it is not required, arrest the track
arm with the lock screw (47).
Cutting depth limiter
Together with the track arm, the cutting
depth limiter (48) makes grooving possi-
ble.
Bevel tilt setting
After loosening the locking lever (49) at
the rear, the track arm holder can be
tilted up to 45° out of vertical to the left.
A
Caution!
When being rotated, the rotat-
ing table may block if the ratchet lock-
ing lever collides with the rear
machine foot. Therefore the lever
position should be adjusted (pull out
and turn) to have sufficient clearance
between lever and machine foot.
A
Caution!
To keep the bevel angle from
changing while sawing, the locking
lever of the track arm holder must be
tightened.
7.1 Rotating Table Lock
Screw Installation
• Insert the lock screw (50) and turn
until tight.
43
44 45 46
47
48
7. Initial Operation
49