Filter
Top Products
OM-175 104 Page 7
3-5. Connecting The Battery
Ref. ST-800 394-B / Ref. ST-178 079-A / Ref. S-0756-D
+
–
3/8,
1/2 in
Y
Connect (–) cable last.
T
ools Needed:
3-6. Weld Output Terminals And Selecting Cable Sizes
Y ARC
WELDING can cause Electromagnetic Interference.
To
reduce possible interference, keep weld cables as short as possible, close together
, and down low
, such as on the
floor. Locate welding operation 100 meters from any sensitive electronic equipment. Be sure this welding machine is
installed and grounded according to this manual. If interference still occurs, the user must take extra measures such
as
moving the welding machine, using shielded cables, using line filters, or shielding the work area.
Total Cable (Copper) Length In Weld Circuit Not Exceeding
100 ft (30 m) Or Less
150 ft
(45 m)
200 ft
(60 m)
250 ft
(70 m)
300 ft
(90 m)
350 ft
(105 m)
400 ft
(120 m)
Weld Output Terminals
Welding
Amperes
10 – 60%
Duty
Cycle
60 – 100%
Duty
Cycle
10 – 100% Duty Cycle
100 4 4 4 3 2 1 1/0 1/0
150 3 3 2 1 1/0 2/0 3/0 3/0
200 3 2 1 1/0 2/0 3/0 4/0 4/0
250 2 1 1/0 2/0 3/0 4/0 2-2/0 2-2/0
300 1 1/0 2/0 3/0 4/0 2-2/0 2-3/0 2-3/0
ST-800 396-A
WORK ELECTRODE
350 1/0 2/0 3/0 4/0 2-2/0 2-3/0 2-3/0 2-4/0
Weld cable size (A
WG) is based on either a 4 volts or less drop or a current density of at least 300 circular mils per ampere.
S-0007-D