Filter
Top Products
OM-1314 Page 15
2-10. Installing Drive Roll And Threading Welding Wire
Ref. ST-149 266-B / Ref. ST-149 326-B / Ref. 150 093-A / Ref. 180 968 / S-0627-A
Install drive roll onto shaft with de-
sired groove in, and one set screw
facing flat side of shaft. Tighten both
set screws.
For Solid Wire
For Flux Cored Wire
WOOD
1 Install drive roll.
2 Open pressure assembly.
3 Pull and hold wire; cut off end.
4 Push wire thru guides into gun;
continue to hold wire.
5 Close and tighten pressure assembly,
and let go of wire.
6 Remove gun nozzle and contact tip.
7 Turn power On.
8 Press gun trigger until wire comes out
of gun.
9 Reinstall contact tip and nozzle.
10 Feed wire to check drive roll
pressure. Tighten knob enough to
prevent slipping. Cut off wire; leave
1/4–1/2 in (6–13 mm). Close and
latch door.
Tools Needed:
6 in
(150 mm)