Filter
Top Products
OM-533 Page 1
SECTION 1 – INTRODUCTION
5-3/4 in.
(141 mm)
9-3/8 in.
(238 mm)
5 in.
(123 mm)
ST-109 521-A
Figure 1-1. Dimensions
1-1. GENERAL INFORMATION AND SAFETY
A. General
Information
presented in this manual and on various
la
-
bels, tags, and plates provided on this unit pertains to
equipment
design,
installation, operation, maintenance,
and
troubleshooting which should be read,
understood,
and
followed for the safe and ef
fective use of this equip
-
ment.
B. Safety
The installation, operation, maintenance, and trouble-
shooting of arc welding equipment requires practices
and procedures which ensure personal safety and the
safety of others. Therefore, this equipment is to be
installed, operated, and maintained only by qualified
persons
in accordance with
this manual and all applica
-
ble
codes such as, but not limited to, those listed in Arc
Welding
Safety Precautions Section in the welding pow
-
er source Owner’s Manual.
Safety
instructions specifically pertaining to this unit ap
-
pear throughout this manual highlighted by the signal
words
WARNING
and
CAUTION
which identify dif
ferent
levels of hazard.
WARNING
statements include installation, operation,
and maintenance procedures or practices which if not
carefully
followed could result in serious personal injury
or loss of life.
CAUTION
statements include installation, operation,
and maintenance procedures or practices which if not
carefully
followed could result in minor personal injury or
damage to this equipment.
A
third signal word,
IMPORTANT
, highlights instructions
which
need special emphasis to obtain the most ef
ficient
operation of this equipment.
1-2. RECEIVING-HANDLING
Before
unpacking equipment,
check carton for any dam
-
age that may have occurred during shipment. File any
claims for loss or damage with the delivering carrier.
Assistance for filing or settling claims may be obtained
from the distributor and/or the equipment manufactur-
er’s Transportation Department.
When requesting information about this equipment, al-
ways
provide the Model Description and Serial Number
.
1-3.
DESCRIPTION
This
unit is a Remote Pendant Control for the Intellipulse
welding
power source. When properly connected to
the
welding
power source this unit provides arc control, con
-
tactor
control, voltage/amperage control, CV/CC selec
-
tion, and pulse frequency selection.