Filter
Top Products
4
Weight: 10.6 oz (300.5 grams) excluding cable and charger
Compliance: CE 93/68/EEC EMC directive (EN 61326:2001)
IEC 61010-1 2001, IEC 60825-1 2001, CFR 1040.10 and
1040.11 except for deviations pursuant to Laser Notice No. 50,
dated July 26, 2001
N.I.S.T. Calibration (RS232 output only)
Mounting: ¼-20 UNC Bushing included (Tripod Mount)
Installation Environment:
Installation Category II per IEC 664
Pollution Degree Level II per IEC 61010-1
Temperature: 32 to 104 °F (0 to +40 °C) operating
14 to 158 °F (-10 to +70 °C) storage
Humidity: Maximum relative humidity of 80% for temperatures
up to 88 °F (31 °C) decreasing linearly to 50% relative
humidity at 104 °F (40 °C)
Specifications subject to change without notice.
2.0 OVERVIEW
The Smart Laser Sensor (SLS) is a self-contained unit intended to be used to
make non-contact speed measurements from rotating targets at distances
up to 65 feet (19.8 m) or to provide non-contact reference points to balancing
equipment. Refer to Section 6.0 for an overview of operation. The unit will
output one (TTL Compatible) pulse per revolution and has the ability to
compute the RPM internally and output the ASCII values to any equipment
capable of receiving an RS232 input. For best performance use reflective
tape for the target.
7
4.5 If after completing step 4.4, the On Target LED (1) blinks
erratically or not at all, rotate the Sensitivity Adjust knob (7)
slowly from 1 to 9 until the LED blinks regularly or is on solid.
4.6 If after completing steps 4.1-4.5, the On Target LED (1) blinks
erratically or not at all:
4.6.1 Move the sensor closer to the target and ensure it is
perpendicular to the target. Repeat steps 4.1-4.5.
4.6.2 Increase the contrast/reflectivity of the target. Repeat
steps 4.1-4.5.
4.7 Once the On Target signal is obtained, use the Polarity Switch
(5) to select a compatible output pulse for your application.
5.0 CONNECTION DETAIL
The unit has an input power jack for
DC power or recharging the batteries.
Use only the PR Universal charger
supplied.
The unit also has a five-pin DIN
output socket for Pulse outputs and
RS232. An 8-foot [2.5 m] cable with
a DIN plug and BNC connector is
supplied. The BNC plug is
connected to the SO output. A
variety of optional cables are
available including: tinned wire
termination, 1/8 inch [3.5 mm] mono
plug, or DB9 for RS-232.
Figure 4 Connection Details
DC Power/Charger
9V 3VA MAX
Use PR Universal ONLY.
Pulse/
RS232
Output