Filter
Top Products
Operating Instructions
12
*
AUTO
MODE
FAN
HEALTH
TEMP
CLOCK SET
TIMER SLEEP
RESET
FILTER RESET
ON/OFF
1
SET
SWING
FRESH
SET
LOCK
RESET
HEALTH
FAN
TEMP
MODE SLEEP
CLOCK
TIMER
ON
OFF
5
LOW
MID HIGH
AUTO
AUTO
LOW
MID
HIGH
A
U
T
O
AUTO
AUTO RUN, COOL,HEAT and DRY operation
Use COOL in summer.
Use HEAT in winter.
Use DRY in spring,autumn and in damp climate.
(1) Unit start
(2) Select operation mode
(3) Select temp. setting
Press ON/OFF button, unit starts.
Previous operation status appears on display
(Not Timer setting). Power indicator lights up.
Press MODE button. For each press, operation mode
changes as follows:
Unit will run in operation mode displayed on LCD.
Stop display at your desired mode.
Every time the button is pressed, temp. setting
increases 1 C.
If button is kept depressed, temp.setting will
increase quickly.
Every time the button is pressed, temp. setting
decreases 1 C.
If button is kept depressed, temp. setting will
decrease quickly.
Recommendations
Hints
Wire controller can memorize each operation status.
When starting it next time, just press ON/OFF button
and unit will run in previous status.
Press FAN button. For each press,
fan speed changes as follows:
(4) Fan speed selection
Unit runs at the speed displayed on LCD.In HEAT
mode, warm air will blow out after a short period
of time due to cold-draft prevention function.
In DRY mode, when room temp. becomes 2 C higher
than temp. setting, unit will run intermittently at
LOW speed regardless of FAN setting.
Unit will start running to reach the temp. setting
on LCD.
Press ON/OFF button.
Only time and room temp remains on LCD.
All indicators go out.
Vertical flap closes automatically.
(5) Unit stop
Press TEMP button
AUTO COOL DRY FANHEAT
AM
Wire controller
Remote controller
Auto running: During the Auto running mode, air conditioning running and can auto-select the cooling, heating, fan
mode according to the room temperature.
Fan running: The AC only have air supply running no cooling and heating running at the condition, AC can't have auto
air supply running, and can't display the setting temperature value on the LCD.
During the heating running, after start the AC, in order to prevent cooled air, AC can stop for a while before send heat
air.
During the dehumification running, when the room temp. setting temp. , not setting condition according to the air speed.
SWING
LIGHT
2
3
4
5