Filter
Top Products
PAGE 22 — EHTX44Y RIDE-ON TROWEL • OPERATION MANUAL — REV. #0 (01/16/13)
OPERATION
STARTING THE ENGINE
1. Place one foot on the trowel's platform, grab hold of the
hand grip located on the front frame, and lift yourself
onto the trowel, then sit down in the operator's seat.
DO NOT use the joysticks to lift yourself onto the trowel.
2. It is recommended that the operation of the Safety Stop
Switch is checked prior to performing any troweling
operations. Doing this will verify that the switch is
working properly contributing to safe operation of the
machine.
3. Place the engine speed control lever, Figure 9 in the
LOW position.
NOTICE
Pulling on the joysticks repeatedly will weaken the
units. ALWAYS use the grab handles to lift yourself
on the trowel.
NOTICE
This trowel is equipped with a safety stop switch that
will not allow the engine to start unless an operator is
sitting in the operator’s seat. The weight of an operator
depresses an electrical switch, which allows the engine
to start.
WARNING
NEVER disable or disconnect the safety stop switch. It is
provided for the operator's safety and injury may result
if it is disabled, disconnected or improperly maintained.
NOTICE
The safety stop switch should be used to stop the
engine after every use. Doing this will verify the switch is
working properly thus providing safety for the operator.
Remember to turn the key to the “OFF” position after
stopping the machine. Not doing so may drain the
battery.
Figure 9. Engine Speed Control Lever (Low)
4. Insert the ignition key into the ignition switch, (Figure 10)
Figure 10. Ignition Switch and Key
5. Turn the ignition key clockwise to the (start) position.
The oil and charge indicator lights, (Figure 11) should
be on.
Figure 11. Oil and Charge Indicator Lights
L
O
W
H
IG
H
ENGINE SPEED
CONTROL LEVER
S
T
A
R
T
E
R
S
W
I
T
C
H
CONTACT
S
T
A
R
T
P
R
E
C
H
A
U
F
F
A
G
E
P
R
E
H
E
A
T
D
E
M
A
R
R
A
G
E
NOTICE
OIL, and CHARGE, indicator lights come on when
ignition switch is in the ON position, and the engine
is NOT running. In COLD weather turn and hold
the ignition key counter clockwise to the PREHEAT
position, wait until the preheat indicator goes off before
turning the ignition key clockwise to the start position.
Two or three preheat cycles may be necessary in very
cold weather.