Filter
Top Products
ASSEMBLY INSTRUCTIONS/OPERATION
SFCS-16 OPERATION AND PARTS MANUAL REV #4 (05/28/09) PAGE 19
DANGER
BLADES ARE EXTREMELY SHARP. CONTACT
WITH THE BLADE CAN RESULT IN PROPERTY
DAMAGE AND/OR PERSONAL INJURY. BLADES
ARE PROVIDED WITH A PROTECTIVE COVER
OVER THE CUTTING EDGE. EXERCISE EXTREME
CAUTION WHEN REMOVING AND/OR
REINSTALLING THE PROTECTIVE COVER. STORE
THE BLADE WITH THE PROTECTIVE COVER
PROPERLY INSTALLED TO MINIMIZE THE
POTENTIAL FOR BLADE DAMAGE AND/OR
PERSONAL INJURY.
7) Return the FLOOR COVERING SCRAPER to its
normal operating position.
8) Determine that the ON/OFF switch located on the
operator handle is in the OFF position. IF the FLOOR
COVERING SCRAPER is to be used immediately,
then reconnect the extension cord or FLOOR
COVERING SCRAPER to the power source.
DANGER
UNEXPECTED MACHINE START UP CAN RESULT
IN PROPERTY DAMAGE AND/OR PERSONAL
INJURY.
Operation
OPERATIONAL DISCLAIMER.
THE MANUFACTURER OF THE FLOOR COVERING
SCRAPER MAKES NO WARRANTY OR
GUARANTEE THAT IT IS MERCHANTABLE
AND/OR SUITABLE FOR ANY SPECIFIC JOB
APPLICATION AND THAT IT WILL HAVE THE
CAPABILITY AND POWER REQUIRED TO
REMOVE ANY SPECIFIC COVERING FROM ANY
SPECIFIC WORK SURFACE.
CALIFORNIA PROPOSITION 65 DISCLAIMER.
DANGER
THE DUSTS/BYPRODUCTS FROM THE COVERING
REMOVAL PROCESS ASSOCIATED WITH THE
OPERATION OF THE FLOOR COVERING
SCRAPER CAN CONTAIN CHEMICALS KNOWN TO
CAUSE CANCER, BIRTH DEFECTS, OR OTHER
REPRODUCTIVE HARM.
INFORMATION RELATIVE TO MINIMUM
COMPONENT STANDARDS FOR THE OPERATION
OF THE FLOOR COVERING SCRAPER.
For operational safety and overall productivity
considerations, it is required that specific FLOOR
COVERING SCRAPER components meet minimum
acceptable operational standards BEFORE utilization:
1) Operator handle be properly mounted to the main
frame, with factory supplied ball-detent type retaining
pins that properly secure the handle to the main frame
while in the work position.
2) The operator handle is equipped with properly fitting
handle grips of sufficient integrity to allow for proper
job function as outlined within this manual. Loose
fitting handle grips or grips without full end caps are
not permitted.
3) An ON/OFF motor switch that allows it to perform its
intended job function as outlined within this manual.
Replace a
ny damaged ON/OFF motor switch with a
factory approved replacement part only.
4) An extension cord and GFI that allows this
accessory to perform its intended job function as
outlined within this manual. Replace any damaged
extension cord or GFI with a factory approved
replacement part only.
5) Exciter plate elastomeric rubber mounts which allow
them to perform their intended job function as outlined
within this manual. Do not operate the FLOOR
COVERING SCRAPER without the correct number of
exciter plate elastomeric rubber mounts. Do not
operate the FLOOR COVERING SCRAPER with a
damaged and/or improperly secured rubber mount.
Replace any damaged rubber mount with a factory
approved repl
acement part only.
6) Blade(s) and/or ceramic tile ripper attachment of
proper structural integrity (void of cracks, etc),
straightness, sharpness, etc which are retained by the
proper fasteners. Replace worn or damaged blades,
fasteners and the ceramic tile ripper attachment with a
factory approved replacement part only.
7) All safety decals, Operator Manual and operational
information decals (including the applicable Quik Tips
information) must be in proper and readable condition.
Replace a
ny missing or damaged safety decal,
Operator Manual and/or information decal with a
factory approved replacement part only.