Filter
Top Products
ASSEMBLY INSTRUCTIONS/OPERATION
SFCS-16 OPERATION AND PARTS MANUAL REV #4 (05/28/09) PAGE 28
surface without first stopping the machine to adjust
mechanical linkages or bend over to operate a crank
lever system. The Back-Saver™ Control System
features a crank lever located on the operator console.
FIGURE 29. Crank the lever clockwise to decrease the
blade angle. Turn the crank lever counterclockwise to
increase the blade angle.
FIGURE 29
5) Typically, adhesive/mastic densities or thickness
change on the job site usually as a result of application
rates on the work surface. This, in turn directly affects
bond densities and thickness. As these factors
change, the blade angle can be adjusted with the Back
S
aver™ Blade Control System to help optimize
covering removal rates.
6) Keep the extension cord free and clear the the main
frame area and orbiting blade/ceramic tile ripper
attachment while the FLOOR COVERING SCRAPER
is in operation. Contact with the blade can damage
the extension cord and create a potential electrocution
concern. In the event of damage, replace the
extension cord with a factory approved replacement
part only.
DANGER
KEEP THE EXTENSION CORD FREE AND CLEAR
OF THE MAIN FRAME AND BLADE AREA WHILE
THE FLOOR COVERING SCRAPER IS IN
OPERATION. CONTACT WITH THE MAIN FRAME
AND BLADE AREA CAN RESULT IN PROPERTY
DAMAGE AND/OR PERSONAL INJURY.
DANGER
IN THE EVENT THE EXTENSION CORD BECOMES
ENTANGLED ABOUT THE FLOOR COVERING
SCRAPER AND/OR THE OPERATOR, TURN THE
ELECTRIC MOTOR ON/OFF SWITCH TO THE OFF
POSITION. FAILURE TO PROPERLY STOP THE
FLOOR COVERING SCRAPER IN THIS
OPERATING CONFIGURATION CAN RESULT IN
PROPERTY DAMAGE AND/OR PERSONAL
INJURY. DETERMINE THE EXTENSION CORD AND
GFI ARE IN PROPER CONDITION TO CONTINUE
OPERATION. REPLACE ANY DAMAGED
COMPONENT WITH A FACTORY APPROVED
REPLACEMENT PART ONLY.
DANGER
DISCONNECT THE EXTENSION CORD FROM THE
FLOOR COVERING SCRAPER WHEN
TRAVERSING UP AND DOWN STAIRWAYS. AN
IMPROPERLY STORED/CONNECTED EXTENSION
CORD CAN ENTRAP AND/OR ENTANGLE
PERSONNEL, RESULTING IN PROPERTY
DAMAGE AND/OR PERSONAL INJURY.
7) Scoring blades are available to remove covering
material such as rubber-backed carpet and linoleum
from concrete and wood surfaces. The vertical ends of
the scoring blade are designed to shear the covering
and remove it in various widths as determined by the
overall blade width. FIGURE 30.
FIGURE 30
CAUTION
Do not operate the FLOOR COVERING SCRAPER
with the vertical ends of the scoring blade facing
down toward the work surface. In this
configuration, damage to the work surface can
result.