Filter
Top Products
SP2S13H20A SAW — OPERATION AND PARTS MANUAL — REV. #1 (05/17/10) — PAGE 23
3. Check V-belt tension (Figure 17) by using a tensionmeter
(6.0 - 9.0 lbs.) against the inside belt at a mid point between
the two pulleys, or by deflecting the center belt at a mid point
3/8” (10 mm) - 1/2” (13 mm).
Figure 17. V-Belt Tension
INSPECTION - BELTS & WATER TANK
Water Tank
The SP2S13H20A Saw is equipped with a removable 5-gallon
on-board water tank fitted in the top of the console which can be
connected to the brass hose fitting on the rear of the operators
console (Figure 18).
Before using the water tank, ensure it is filled to capacity and
connected to the hose fitting to provide lubrication during cutting.
An external water source can also be connected to the
SP2S13H20A for extended wet cutting operations.
Figure 18. On-board Water Tank Hose Connection
4.
DO NOT over or under tension the V-belts. Severe damage
can occur to the saw and engine crank shaft if the belts are
over tensioned. A decrease of power to the blade and poor
performance will result if the belts are under tensioned (loose
on pulleys).
5. If the V-belts becomes worn or loose, see Table 5 for
replacement part numbers.
Table 5. V-Belts and Pulleys
Part Name Part Number Qty
V-Belt 16052 3
Engine Pulley 23703-003 1
Blade Shaft Pulley 25172-003 1