Filter
Top Products
SP2S13H20A SAW — OPERATION AND PARTS MANUAL — REV. #1 (05/17/10) — PAGE 29
Saw Alignment
1.
The SP2S13H20A saw employs a front pointer (Figure 42)
that has been precisely aligned with the diamond blade at the
factory. Referencing the figure below, accurate tracking is
accomplished by referencing the front pointer tip over the cut
line. Precise saw direction is accomplished by slight operator
pressure against the handle bars.
Figure 42. Saw Pointer
2.
To reorient a pointer position, loosen the screw that secures
the pointer bar to the shaft, adjust as necessary, and retighten
the screw.
OPERATION
Traveling During Cutting
The SP2S13H20A saw has a hydrostatic transmission which
mechanically propels the saw during cutting operations. To
prepare the machine for self-propelled cutting:
1. Place the
travel lever
in the NEUTRAL position.
Figure 39. Transmission Engage/Disengage Lever
(Engage Position)
DO NOT force the blade into the cut any faster than its
designed tendency is effective cut and remove material. This
can damage your blade and/or your machine.
3. Move the
travel lever
towards the FORWARD position to
increase forward travel speed during cutting (Figure 40).
Placing the travel lever fully forward will move the saw at
maximum speed.
2. Lift the
transmission
engage/disengage lever,
located on the console (Figure 39). Leaving the lever down
disengages the transmission to allow for manual pushing
during cutting or moving the machine around the job site.
Figure 38. Transmission Engage/Disengage Lever
(Neutral Position)
Figure 40. Transmission Engage/Disengage Lever
(Forward Position)
4. When reverse movement is required, move the
travel lever
towards the REVERSE position (Figure 41). Placing the
travel lever fully in reverse will move the saw backwards at its
maximum reverse speed.
Figure 41. Transmission Engage/Disengage Lever
(Reverse Position)
CAUTICAUTI
CAUTICAUTI
CAUTION