Filter
Top Products
TP7X TILE SAW • OPERATION MANUAL — REV. #0 (03/04/11) — PAGE 17
SET-UP
Figure 5. Support Stand Assembly
CONNECTING THE WATER PUMP
Refer to Figure 6.
1. Place the pump into the middle of the water tray along
its side so that the water outlet is positioned horizontally.
2. Attach the water hose coming from the blade guard
and bearing housing to the water pump.
3. Install drain plug in water tray.
4. Fill the water tray with clean fresh water. The water
pump intake must always be fully covered by water.
Also, keep the pump intake free of sludge, debris and
other materials that may accumulate in the tray.
5. Make certain that the water hose will not come in contact
with the blade or interfere with any moving parts.
Figure 6. Connecting the Water Pump
WATER
PUMP
BLADE
GUARD
BEARING
HOUSING
WATER
HOSES
DRAIN
PLUG
6. Insert the water pump power plug into the outlet receptacle
on the electric motor conduit box as shown in Figure 7.
Figure 7. Water Pump Power Connection
ELECTRIC WATER
PUMPAC
RECEPTACLE
ELECTRIC MOTOR
CONDUIT BOX
POWER
PLUG
WATER
PUMP
WARNING
Disconnect the pump before attempting to handle the
pump. NEVER operate pump without water in the tray.
NOTICE
The above procedure is for wet cutting applications only.
NEVER dry cut with the pump connected to an AC power
source. Running the pump dry will damage the pump.
ALWAYS disconnect the pump’s power cord when dry cutting.