Filter
Top Products
TP7X TILE SAW • OPERATION MANUAL — REV. #0 (03/04/11) — PAGE 21
2. After the template base is positioned for the desired
rip cut, place material flat against either side of the
template base at the desired measurement.
Using the Rip Guide
1. Set the rip guide (Figure 12) at the desired location on
the ruler guide and tighten the threaded knob. Make
sure that the rip guide is firmly tightened to avoid
slippage. The rip guide can be used for 45° and 90°
cuts.
2. After the rip guide is positioned, for the desired cut,
place material flat against the rip guide and ruler guide.
3. Now you are ready to make your cut.
Performing Diagonal Cuts
1. Place the corner of the material in the open slot of the
measurement rail and adjust the template base to fit
the correct tile size.
2. Line up the material being cut with the appropriate
pre-marked lines on the cutting table.
3. Now you are ready to make your cut.
Performing Miter Cuts
Use the miter block to make miter cuts. See Figure 13.
1. Place the lip of the miter block on the ruler guide with
the threaded knob facing you.
2. Position the miter block such that a tile laying flat
against the block may rest its left-most edge within
the vertical channel of the cutting table. Tighten the
threaded knob to secure the miter block in place.
3. Place material onto miter block and you are ready to cut.
Figure 13. Miter Block
SAWING GUIDES