Filter
Top Products
10
TOP PLATE TO STAND
1. Place the top plate (A) Fig. 10, on the top of the
stand (B).
2. Align the six square holes on the top plate (A) Fig.
10, with the six square holes in the stand (B).
3. Align the two square holes on the side of the plate
(A) Fig. 10, with the two square holes on the side of the
stand (B).
4. Insert a 5/16-18x3/4" carriage head bolt through the
top plate and the stand. Thread a 5/16-18 hex nut on to
screw.
5. Repeat this process for the five remaining holes in
the top of the plate and stand, and the two holes in the
side of the top plate and the stand. Make sure the door
opening is at least 13" wide before tightening the
screws.
Fig. 10
DUST CHUTE
1. Insert the dust chute from inside the stand through
the opening (A) Fig. 11, in the top of the stand.
NOTE: MAKE SURE THE TAB (B) FIG. 12, IN THE
DUST CHUTE, ENGAGES THE CUTOUT (C) IN THE
TOP OF THE STAND.
2. Align the two slotted holes (D) Fig. 13, in the bottom
of the dust chute with the two holes (E) Fig. 14, in the
stand.
Fig. 11
Fig. 12
Fig. 14Fig. 13
A
B
A
B
C
D
E