Filter
Top Products
12
6. Align the two holes in the hinge (C) Fig. 19, with the
two holes in the stand door (D). MAKE SURE THAT THE
HINGE OPENING IS POINTING DOWN.
7. Insert a #10-24x1/2" socket head cap screw through
the hole in the door, and thread the screw into the hole
in the hinge. Repeat this process for the remaining hole
in the door and the hinge. NOTE: DO NOT
COMPLETELY TIGHTEN THE SCREWS AT THIS
TIME.
8. Repeat this process for the remaining hinge.
9. Make sure the two hinges are aligned with each
other by using a straight edge as shown in Fig. 20.
10. Tighten the four screws securely, that attach the
hinges to the door.
Fig. 19
Fig. 20
11. Slide the two hinges (C) Fig. 21, on the door, over
the two hinge catches (A) on the stand.
Fig. 21
12. Insert the door latch (F) Fig. 22, from the outside,
through the hole in the door.
13. Push down on the door latch to snap the latch in
place.
14. To open or shut the door, slide the latch away from
the cabinet and pull or push the door.
Fig. 22
F
C
C
A
A
C
D