Filter
Top Products
17
7. Insert the switch cord (H) Fig. 39, through the hole in
the cord bushing (G).
8. Insert the pronged motor plug (J) Fig. 40, into the
receptacle (H) of switch cord.
MAKE SURE THAT THE MOTOR PLUG
(J) FIG. 40 AND THE SWITCH CORD (H)
ARE ROUTED BEHIND THE DUST
CHUTE (K). IF THE BAND SAW IS
BEING USED WITH THE ACCESSORY
HEIGHT ATTACHMENT THE THE CORD
HAS TO BE ROUTED IN FRONT OF THE
DUST CHUTE.
Fig. 39
Fig. 40
OPERATING CONTROLS AND ADJUSTMENTS
STARTING AND
STOPPING SAW
The power switch is located on the left side of the
machine. To turn the machine “ON”, push the green
start button (A) Fig. 41. To turn the machine “OFF”, push
the red stop button (B).
Fig. 41
LOCKING SWITCH IN THE
“OFF” POSITION
IMPORTANT: When the tool is not in use, the switch
should be locked in the “OFF” position to prevent
unauthorized use, using a padlock (C) Fig. 42 with a
3/16" diameter shackle.
Fig. 42
H
G
C
A
B
H
J
K