Filter
Top Products
11
BAND SAW USED WITH A DUST
COLLECTOR
3. If you are going to use your band saw with a dust
collector, attach the dust port as follows:
A. Align the four holes in the dust port (A) Fig. 15,
with the four holes in the side of the stand.
B. Insert a #10-32x1/2" pan head screw through
the two holes in the dust port (B) Fig. 15, and
stand. Thread a #10-32 hex nut onto the screw,
and tighten securely.
C. Repeat this process for the two remaining
holes (C) in the dust port, stand, and dust chute.
NOTE: THE DUST CHUTE WILL ONLY BE
ATTACHED WITH THE TWO BOTTOM HOLES
(C) IN THE DUST PORT.
Fig. 15
BAND SAW USED WITHOUT A
DUST COLLECTOR
3. If you are not going to use a dust collector with your
band saw proceed as follows:
A. Insert a #10-32x1/2" pan head screw through
hole (A) Fig. 16, in the stand and dust chute.
Thread a #10-32 hex nut onto the screw, and
tighten securely.
B. Repeat this process for the remaining holes in
the stand. NOTE: THE DUST CHUTE WILL
ONLY BE ATTACHED WITH THE TWO
BOTTOM HOLES IN THE STAND.
Fig. 16
STAND DOOR TO STAND
1. Align the two holes in the hinge catch (A) Fig. 17,
with the two holes on the stand. NOTE: MAKE SURE
THE HINGE CATCH (A) IS POINTED UP AS SHOWN
IN FIG. 17.
2. Insert a #10-24x1/2" socket head cap screw
through the hole in the stand, (from the inside of the
stand), and thread the screw into the hinge catch.
Repeat this process for the remaining hole in the stand
and hinge catch. NOTE: DO NOT COMPLETELY
TIGHTEN THE SCREWS AT THIS TIME.
3. Attach the other hinge catch in the same manner.
4. Make sure the two hinge catches are aligned with
each other by using a straight edge as shown in Fig18.
5. Tighten the four screws securely, that attach the
hinge catches to the stand.
Fig. 17
Fig. 18
A
A
A
B
C
C
B