Filter
Top Products
11
DISCONNECT TOOL FROM POWER SOURCE.
1. Support motor clamp (Fig. 5A)
and loosen motor clamp screw
approximately 1/2" with the hex
wrench (furnished).
2. Insert motor unit into the base
with switch positioned at front of
left handle, and align the four
pins (A) Fig. 6 in the motor case
with the slots (B) Fig. 6 in the
base.
3. Seat the motor in the base and
tighten the motor clamp screw.
REMOVING MOTOR
DISCONNECT TOOL FROM POWER SOURCE.
1. Remove clamp screw (A) Fig. 5A, flat washer (B), lock washer (C), and
clamp-locking nut (A) Fig. 5B.
2. Insert hex wrench (A) Fig. 7 to contact locking plate. Tap lightly to
release and remove locking plate.
3. Slide motor out of base.
4. Reassemble clamp screw, lock washer, flat washer, locking plate and
clamp locking nut to the base and tighten lightly to prevent loss.
INSTALLING AND REMOVING THE BIT
Be certain that the power switch is in the “OFF” position and
tool is disconnected from power source to avoid accidental
starting of motor which could result in injury.
]
1
/2"
Fig. 5A
Fig. 5B
A
B
C
D
A
B
B
A
Fig. 6
6931 BASE
INSTALLING THE MOTOR